6,000 + (and growing) factories in our existing network are eager to make it for you.
When it comes to selling in stock products, we are no difference from many other Internet retailers, but we take pride in going extra miles to do something special for you: Have some products custom made for you.
We cannot do everything, but we usually can accommodate a certain changes in product options such as color, size, material, or minor design twist. We primarily work with vendors or factories, not individual artist or craftsman. For custom made products, we usually only cater to bulk size order that meets the minimum quantity requirement of a single factory run. Don't be shy. Ask. What we can accomplish may surprise you!
Firestone Lap Sealant HS is designed to be used with Firestone Splice Adhesive for seam edge treatment applications and as a sealant in other applications as indicated by current Firestone Specialty Products specifications and details. This product requires Haz-Mat Shipping and cannot be shipped UPS Next-Day Air, Second-Day Air or Three-Day Select Firestone Lap Sealant HS Method of Application Surfaces to which Firestone Lap Sealant HS is applied must be clean, dry, free of foreign materials and excess dusting agent. Clean with broom or rags if necessary.
Wait Before Applying Seam Edge Treatment Wait to apply seam edge treatemnt a minimum of 4 hours after completion of a flashing unless weather is threatening. If weather is threatening, apply Firestone Splce Adhesive to the edge of the flashing splice (next step below) before leaving the project. If weather is not threatening, the seam edge must be applied no later than the end of the next day following the completion of the seam.
Coat Flashing Step-Off: Apply a layer of Firestone Splice Adhesive along the entire seam edge, a minimum of 1" on each side of the step-off following current Firestone Splice Adhesive application procedures. Allow the Splice Adhesive to flash off. Note: If the seam edge has beeen contaminated, clean the seam edge a minimum of 1" on each side of the step off with Firestone QuickPrime Plus and allow to dry, prior to application of the seam edge treatment.
Apply Firestone Lap Sealant HS Apply a continuous bead of Lap Sealant HS approximately 3/8" x 1/4" centered over the flashing seam edge, using the plastic nozzle applicator supplied by Firestone. Be sure to keep the nozzle applicator centered over the lap step off. Refer to seam details.
Firestone Lap Sealant HS Coverage Rate Approximately 20-22 linear feet of 3/8" x 1/4" bead per 11 oz tube
NOTE: International/PO box deliveries are not available.
This product does not ship to the APO address and the following addresses: HI, AK, PR.
Need more information?
Our staff are available to answer any questions you may have about this item